To gain access to the auto frother unit simply grasp the dispenser cover and lift upward. Slip over the auto frother pin or remove the pin before lifting cover.

Remove the auto frother unit by gripping firmly and pulling away from the machine.. The frothing unit will simply slide off although sometimes it may give resistance.

It may be necessary to hold the door with your other hand while pulling the frothing unit. Pull milk tube off frothing unit and seperate into four pieces (top, body, pin and elbow).

To clean the frothing unit remove the top by pulling off with fingers and thumb. Use the aperture pin supplied to clear the small aperture though which steam enters the unit of built up milk fat. If this hole is not kept clear the frothing system will give poor performance and milk flow. Clean inside of unit and grey tube with a bottle brush. Replace top by pushing back onto unit ensuring seal is good. To reattach unit simply slide back onto the machine. To clean milk line replace milk in jug with cold water and PRESS hot milk button to flush line. If trapped milk is identifed in the line pinch hose to dislodge and remove through the line.

To open the door to the machine simply grasp the dispenser and pull to release magnetic switch and swing door out from the left hand side.

To remove the brew unit firstly remove the drip tray by holding with both hands and lifting while pulling away from the machine. Clean the drip tray with a brush and turn the grill upside down to remove old milk.

To remove the brew unit grasp with right hand and push down on PUSH word with thumb while pulling away from the machine. Rinse brew unit under running warm tap to remove coffee grounds. Reinsert brew unit by matching tabs on bottom with mounting tracks.

For clarification on any step call 9486 6939 or 0413 120 382 Email us at service@coffeemachinerentals.com.au